VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

MANUAL & AUTOMATIC,

DIESEL  2012 ON

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS, MANUAL & AUTOMATIC, DIESEL  2012 ON

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS, MANUAL & AUTOMATIC, DIESEL 2012 ON

FITTING INSTRUCTION FOR A VW AMAROK

The DTCO can be mounted in centre console, as the DTCO is not in the direct line of sight please use the T warning light this is supplies in the kit

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

The KITAS 2 + SENDER UNIT WILL BE SCREWED  IN TO THE DIFFERENTIAL

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

VW AMAROK TACHOGRAPH FITTING INSTRUCTIONS

THE VW AMAROK KITAS 2 + SENDER

VW AMAROK KITAS SENDER

VW AMAROK KITAS SENDER

EXTRA PARTS REQUIRED FROM VW IF NO SECOND RADIO COMPARTMENT 

VW AMAROK TACHOGRAPH FITTING

VW AMAROK TACHOGRAPH FITTING

VW AMAROK TACHOGRAPH FITTING

VW AMAROK TACHOGRAPH FITTING

Installation of Geoloc

In order the prevent GPS sensivity issues, the module needs to be installed in a position where the module has a clear view to the sky and satellities.

 

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTUCTIONS  AUTOMATIC 2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTUCTIONS
AUTOMATIC 2003 ON GEOLOC

1- When installing the Geoloc module in vehicle, make sure that are as few obstrutions as possible close to the unit since it has a internal GPS antennta. Any obstruction might block the 360 view to horizon that is required for good operation. ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.

2- The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate ( Antenna side of the module) should face upwards towards the sky (See image below).

PLEASE NOTE: The Geoloc is equipped with a 120 Ohm can resiter. The CAN wiring to CAN 1 or Can 2 must take into account !

Geoloc To CAN 2 of DTCO 1381 Release 2.0a Plug connections

CABLE COLOUR DESCRIPITION DTCO PIN CONNETIONS

WHITE                                IGNITION                          A3

BLACK                                GROUND                            A5

RED                                    SUPPLY (9-36V)                A1

GEOLOC – CTC 11 PROGRAMMING

The source for the 2nd motion signal can be set in path

PROGRAMMING / INSTALLATION DATA / IMS SIGNAL / SOURCE.

The following setting is for CAN 2:

– CAN 2 GEOLOG (external source e.g GPS)

FITTING KIT A2C59515489

VW AMAROK TACHOGRAPH KIT

VW AMAROK TACHOGRAPH KIT

BUY KIT HERE