POUND
Euro
English
French
German
Spanish
RussianVAUXHALL VIVARO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON
TACHOGRAPH KIT PART NUMBER: 13810527
VEHICLE MANUFACTURER: Vauxhall,
MODEL: VIVARO
TRANSMISSION: Manual (with modification)
YEAR: 2005 on
ENGINE: Diesel
VOLTAGE: 12v
V5-05-03-13
As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a
legal requirement that an independent motion signal is connected to an activated
DTCO, Therefore for this digital installation a DTCO Geoloc is required part number
A2C59514979
FITTING INSTRUCTIONS
Remove the blanking plug from the gearbox (PF6 or modified) and install and seal the KITAS sensor supplied.
VAUXHALL VIVARO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON
Install the DTCO Tachograph in the spare radio DIN location or underneath the steering column.
VAUXHALL VIVARO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON
If the Tachograph is installed underneath the steering column, a LED warning light (supplied)60755804 must be fitted and marked with the letter ‘T’
VAUXHALL VIVARO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON
VAUXHALL VIVARO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON
The warning light is wired via D4 of the DTCO and a 12v positive feed
Fitting Kit 13810527 consists of:-
QUANTITY PART DESCRIPTION PART NUMBER
1 DTCO TACHOGRAPH 1381-0050209001
1 PLUG & HARNESS 1318-90100000
1 SENDER UNIT 2171-08010010
1 SENDER CABLE 21700421
1 YELLOW LED WARNING LIGHT 60755804
1 BROWN MINITIMER PLUG HS53-6600-084
1 DTCO INSTALLATION HOUSING X39-140-000-011
1 DTCO INSTALLATION CAGE 1324-90010500
1 DTCO OPERATING INSTRUCTIONS BA00-1381-20101102
WHITE INGINTION A3
BLACK GROUND A5
RED SUPPLY (9-36V) A1
Installation of Geoloc:
Installation instructions
In order to provent GPS sensitivity issues, the module needs to be installed in a position where the module has a clear view to sky and satellites.
1- When installing the geoloc module in a vehicle, make sure that there are as few obstruction as possible close to the unit since it has an internal GPS antenna. Any obstruction might block the 360 view to the horizon that is required for operation. Ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.
2- The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate (antenna side of the module) should face upwards towards the sky
PLEASE NOTE: The Geoloc is equipped with 120 Ohm can resistor. The wiring to CAN 1 or CAN 2 must take this into account!
Whilst every effort is made to ensure the accuracy of the information given here, TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.