POUND
Euro
English
French
German
Spanish
RussianFORD RANGER TACHOGRAPH FITTING INSTRUCTIONS
MANUAL 2012 DEISEL 12V
Ford ranger tachograph fitting instructions
1- Remove blanking plug that is found on gearbox and install the 2171-20002301 that is supplied in the kit
Ford ranger tachograph fitting instructions
2- The sender cable can be routed underneath the vehicle and fed through the grommet
on the nearside under the bonnet and though to underneath the glove box
Ford ranger tachograph fitting instructions
The DTCO will be located in the coin tray with supplied cover
Ford ranger tachograph fitting instructions
All The electrical connections can be found on a grey plug found behind the centre consol
Ford ranger tachograph fitting instructions
Ford ranger tachograph fitting instructions
3- Remove the grey plug and replace it with the A plug supplied in the kit
Ford ranger tachograph fitting
Ford ranger tachograph fitting instructions
Ford ranger tachograph wiring overview
Ford ranger tachograph wiring
4- Connection independent motion signal (IMS)
The IMS will connected to OBD plug 3 to 11
The OBD plug can be found behind the compartment above the bonnet catch
Ford ranger tachograph fitting
QUANTITY PART DESCRIPTION PART NUMBER
1 DTCO TACHOGRAPH 1381-0210209002T
1 PLUG & HARNESS 1381-90100000
1 SENDER UNIT 2171-20002310
1 SENDER CABLE 21700421
1 DTCO MOUNTING SLEEVE 1324-90010005
1 DTCO REAR SEALING COVER 1381-90020100
1 DTCO REAR SEALING COVER SCREW HS07-0100-116
1 DTCO OPERATING INSTRUCTIONS BA00-1381-20101102
1 FORD RANGER PANEL COVER T1535
As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a connection must be made on the OBD plug. Using the CTCII the tachograph must be programmed to Ford Ranger
Whilst every effort is made to ensure the accuracy of the information given herei,TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.