MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL,  2003 ON

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

Manual 2003 ON

Diesel CDI 109 111 115

Petrol Vito 119 Vito 122

12v

FITTING INSTRUCTIONS

As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a DTCO Geoloc is required part number A2C59514979

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

Fitting Kit 13810504 consists of:-

QUANTITY PART DESCRIPTION PART NUMBER

1 DTCO TACHOGRAPH 1381-0050209001

1 CONNECTING CABLE X39-132-400-001

1 SENDER UNIT 2171-32210440

1 DTCO REAR SEALING COVER 1381-90020100

1 DTCO REAR SEALING COVER SCREW HS07-0100-116

1 DTCO OPERATING INSTRUCTIONS BA00-1381-20101102

CABLE COLOUR              DESCRIPTION           DTCO PIN CONNECTION

WHITE                            INGINTION                         A3

BLACK                             GROUND                          A5

RED                                SUPPLY (9-36V)                A1

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2003 ON

Installation of Geoloc:

Installation instructions

In order to provent GPS sensitivity issues, the module needs to be installed in a

position where the module has a clear view to sky and satellites.

1-  When installing the geoloc module in a vehicle, make sure that there are as few obstruction as possible close to the unit since it has an internal GPS antenna. Any obstruction might block the 360 view to the horizon that is required for operation. Ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.

2-  The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate (antenna side of the module) should face upwards towards the sky

PLEASE NOTE: The Geoloc is equipped with 120 Ohm can resistor. The wiring to CAN 1 or CAN 2 must take this into account!

Whilst every effort is made to ensure the accuracy of the information given here,TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.