POUND
Euro
English
French
German
Spanish
RussianMERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS
AUTOMATIC, 2003 ON DIESEL & PETROL 12
MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, 2003 ON
VITO TACHOGRAPH FITTING INSTRUCTIONS
As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a DTCO Geoloc is required part number A2C59514979
VITO TACHOGRAPH FITTING INSTRUCTIONS
There is a blind plug on the vehicle transmission which must be removed
Fitting kit 13810507 consists of:
MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, 2003 ON
Mounting of deco in installation console
MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, 2003 ON
In vehicles where both radio compartments are occupied, an installation console can be mounted. The installation console can be purchased via the Daimler chrysler agency under the DC part number A639 680 00 31 7D 53 8 j06 (gray)
MERCEDES BENZ VITO TACHOGRAPH FITTING INSTRUCTIONS, 2003 ON
Radio compartment
Time required for installation approx 2 1/2 hours
Installation of Geoloc
In order the prevent GPS sensivity issues, the module needs to be installed in a position where the module has a clear view to the sky and satellities.
1- When installing the Geoloc module in vehicle, make sure that are as few obstrutions as possible close to the unit since it has a internal GPS antennta. Any obstruction might block the 360 view to horizon that is required for good operation. ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.
2- The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate ( Antenna side of the module) should face upwards towards the sky.
PLEASE NOTE: The Geoloc is equipped with a 120 Ohm can resiter. The CAN wiring to CAN 1 or Can 2 must take into account !
Geoloc To CAN 2 of DTCO 1381 Release 2.0a Plug connections
CABLE COLOUR DESCRIPITION DTCO PIN CONNETIONS
WHITE IGNITION A3
BLACK GROUND A5
RED SUPPLY (9-36V) A1
GEOLOC – CTC 11 PROGRAMMING
The source for the 2nd motion signal can be set in path
PROGRAMMING / INSTALLATION DATA / IMS SIGNAL / SOURCE.
The following setting is for CAN 2:
– CAN 2 GEOLOG (external source e.g GPS)
Whilst every effort is made to ensure the accuracy of the information given here,TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.