MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

 

CABLE COLOUR              DESCRIPTION           DTCO PIN CONNECTION

WHITE                            INGINTION                         A3

BLACK                             GROUND                          A5

RED                                SUPPLY (9-36V)                A1

ASG (Sprint Shift)

INSTRUCTIONS, 2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS:

As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a DTCO Geoloc is required part number A2C59514979

FITTING INSTRUCTIONS –

  1. Remove the blanking plug if from the rear ofthe RH side of the transmission and install the new sender unit and cable in the transmission with a new/existing bolt and route the cable through the left-hand bulkhead gaiter into the cab.
  2. Remove the cubby-box liner from the DTCO position and insert the metal Trim Sleeve supplied. Bend back the appropriate tabs to secure.
  3. Wire up A1/A5/A6 of the Plug and Harness supplied, to the adjacent cigar lighter socket and wire up A2/A3 to a suitable panel light feed (58) and ignition feed (15) in the electrical compartment below the steering column.

4. Insert the WHITE and YELLOW plugs in the A and B sockets at the rear of the DTCO and fit the Plug and Harness Sealing Cover Supplied. Insert one of the Red Seals supplied in the Sealing Cover embossed with your GB seal no. Slide the DTCO into position until locked.

5. Secure all cables allowing for the MTCO to be withdrawn.

6. Complete the calibration and sealing of the installation.

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, ASG, SPRINT SHIFT,2003 ON

Installation of Geoloc:

Installation instructions

In order to provent GPS sensitivity issues, the module needs to be installed in a position where the module has a clear view to sky and satellites.

1-  When installing the geoloc module in a vehicle, make sure that there are as few obstruction as possible close to the unit since it has an internal GPS antenna. Any obstruction might block the 360 view to the horizon that is reguired for operation. Ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.

2-  The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data platev (antenna side of the module) should face upwards towards the sky.

Whilst every effort is made to ensure the accuracy of the information given here,TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.