POUND
Euro
English
French
German
Spanish
Russian
MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, 4 WHEEL DRIVE, 2003 ON
MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, 4 WHEEL DRIVE, 2003 ON
4 Wheel drive
INSTRUCTIONS 2013 ONWARDS
As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a DTCO Geoloc is required part number A2C59514979
Fitting Kit 13810506 consists of:-
|
QUANTITY |
PART DESCRIPTION |
PART NUMBER |
|
1 |
DTCO TACHOGRAPH |
1381-0050209001 |
|
1 |
INSTALLATION SLEEVE TRIM |
1324-90010500 |
|
1 |
SENDER UNIT |
2171-32210440 |
|
1 |
PLUG & HARNESS |
1318-90100000 |
|
1 |
DTCO REAR SEALING COVER |
1381-90020100
|
|
1 |
DTCO REAR SEALING COVER SCREW |
HS07-0100-116 |
|
1 |
DTCO OPERATING INSTRUCTIONS |
BA00-1381-20101102
|
Installation of Geoloc
Installation of Geoloc
Installation Instructions:
In order to prevent GPS sensitivity issues, the module needs to be installed in a position where the module has a clear view to the sky and satellites.
1. When installing the Geoloc module in a vehicle, make sure that there are as few obstructions as possible close to the unit since it has an internal GPS antenna. Any obstruction might block the 360 view to the horizon that is quires for goo operation. Ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.
2. The GPS receiver entenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate (antenna side of the module) should face upwards towards the sky (see image below).
MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, 4 WHEEL DRIVE, 2003 ON
MERCEDES BENZ SPRINTER TACHOGRAPH FITTING INSTRUCTIONS, 4 WHEEL DRIVE, 2003 ON