IVECO DAILY TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON

IVECO DAILY TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON

IVECO DAILY TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON

Manual

2005 onwards

Diesel 2.3 HTP 2.81 3.0I HPT

12v

As from 1st October 2012 According to Regulation (EU) No 1266/2009 (Annex1b) it is a legal requirement that an independent motion signal is connected to an activated DTCO, Therefore for this digital installation a DTCO Geoloc is required part number A2C59514979.

FITTING INSTRUCTIONS

1. Remove the existing speedometer Sender Unit from the vehicle gearbox and replace with the KITAS2 Sender Unit supplied.

2. Remove the Cubby Box liner from the DTCO position in the dashboard, the white, yellow DTCO connecting plugs (with insulating tape) become visible.

3. Release the cable ties retaining the DTCO wiring plugs located at the rear of the DTCO aperture (second radio position).

4. Disconnect the link harness joining the DTCO plugs A, B (see below)

5. Insert the Installation Sleeve Trim in the DTCO aperture and bend back the tabs to secure.

6. insert the DTCO plugs in their respective sockets.

7. Fit the Plug and Harness Sealing Cover to the DTCO and secure with a Red Seal embossed with your GB no. Slide the DTCO into the aperture until fully locked.

8. Complete the calibration and sealing procedures as normal.

IVECO DAILY TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON

IVECO DAILY TACHOGRAPH FITTING INSTRUCTIONS, MANUAL, 2005 ON

Fitting Kit 13810511 consists of:-

QUANTITY PART DESCRIPTION PART NUMBER

1 DTCO TACHOGRAPH 1381-0050209001

1 SENDER UNIT 2171-20006110

1 INSTALLATION SLEEVE TRIM 1324-90010500

1 DTCO REAR SEALING COVER 1381-90020100

1 DTCO REAR SEALING COVER SCREW HS07-0100-116

1 DTCO OPERATING INSTRUCTIONS BA00-1381-20101102

Installation of Geoloc:

Installation instructions

In order to provent GPS sensitivity issues, the module needs to be installed in a position where the module has a clear view to sky and satellites.

1-  When installing the geoloc module in a vehicle, make sure that there are as few obstruction as possible close to the unit since it has an internal GPS antenna. Any obstruction might block the 360 view to the horizon that is required for operation. Ideally, nothing should block the antenna beyond 5 degrees above the horizon with the best location being on the windscreen.

2-  The GPS receiver antenna (Patch-Antenna) is located underneath the type data plate. Therefore the data plate (antenna side of the module) should face upwards towards the sky

PLEASE NOTE: The Geoloc is equipped with 120 Ohm can resistor. The wiring to CAN 1 or CAN 2 must take this into account!

Whilst every effort is made to ensure the accuracy of the information given here, TACHO SUPPLIES Ltd cannot be held responsible for any errors or omissions. Ultimately, the installer must ensure compliance with the specific vehicle repair procedures laid down by the vehicle manufacturer; particularly with regard to battery disconnection/reconnection procedures. Failure to comply with the vehicle manufacturer’s instructions may result in personal injury and/or component damage/memory loss.